Reliance BPO
Reliance BPO

Reliance Placement Paper

Company: Reliance BPO Private Limited


1. Mental Ability

There were 75 questions in this section,the time allotted was 30 minutes.Most of the questions will have six options.There r questions where u have to fill the blank space in the OMR answer sheet.The cut off was around 45 questions

The questions was on Series,General English,Coding,focus on English Verbal etc . R.S. Agarwal is sufficient.

2. In the second section questions were based on subject which u have opted I m giving the questions for Instrumentation,
this section was having 50 questions to be attempted in 30 minutes as

-Flow meter used for mass flow measurement

Options as Positive displacement/Venturi meter/Orifice meter

-Displacement type level measurement is based on

Options as Archimedes/Newton

-Pin no. 3 in op-amp is for

Options as Inverting/Non inverting input

-One question was on Zener Diode

-One figure was given asked what it is-

Options as Integrater/Differentiator

-Response of Turbine flowmeter is

Options as Linear/Non linear

-Sensitivity is highest of

Options as Thermistor/Thermocouple

-1 mil is equal to

Options as 1 cm/14.7/10 mm

-1atm is same as

Options as 1bar/1psi/1kg/m3

-Two questions were based on Orifice meter

-Two questions were based on Magnetism and Para magnetism

-Convert 1000 in decimal

-Convert 6 into Binary

-Noise is minimum in

Options Optical fiber cable/Twisted wire cable

-Assembly language is converted into machine language by

Options Compiler/Assembler

-One question was on computer memory


-In displacement level measurement when the float goes down then reading

Options as increases/decreases/remains same

-One question was based on common ground problem in electrical wiring

-One question was on PID controller

-Pirani is used for

Options as Thermal Conductivity

-One question was again on flowmeters

-The full form of TCP/IP

-The full form of ISO

-Temperature sensor to sense the temperature of the order of 2000 degrees celcius is

Options as Pyrometer/Thermister/Thercouple

-The thermocouple representing K is

Options as Copper-Zinc/

-The thermocouple represnting J is

Options as Iron Constantan/

-One question was on Magnetic flow measurement

-Highly distilled water has

Options as poor conductivity/high conductivity/medium

-One question was on gas analysis H2/O2 in a gas can be known using the set up

-One question was on MOSFET

These r around 30 questions which I m remembering. The cut off was around 25 questions.

On 4th of April I was having Interview the Interview was completely Technical existing for a time duration of 20 to 25 minutes.I had my interview for only 14 minutes

Technical interview:

The questions are as follows:

1.Explain your technical background

2.What is Process Control

3.What is Feedback Process Control

4.Explain your B.TECH project

5.Types of flow meters and explain any one

6.What is your technical aim in life

7.Have u visited any plant

8.About Summer training

Reliance Placement Paper

About Reliance

Read More